A stone chip and a long crack look like similar damage, but they behave differently under a repair tool. Pressing down on a long crack can squeeze it shut, which leaves air pockets and spots. This article explains the problem and the design ideas behind tools made for long cracks. It is general information for professional technicians, so confirm details with the manufacturer and follow their instructions.
The Core Problem With Long Cracks
Ultra Bond says flexing down on the glass when repairing a long crack pushes the crack closed, causing an under-fill and spots. A tool that holds pressure in the wrong place can make the repair worse.
Design Ideas Worth Knowing
The company’s long crack tool has a single custom suction cup placed at a proper distance from a sliding injector, so the tool does not flex the glass. It describes leveling nuts for automatic leveling, and a center pressure bolt for extra pressure when needed. Its listing says the injector holds 36 drops of resin and slides along the crack.
Crack Length and Scope
The company’s upgrade page mentions repairing cracks up to 14 inches long. Whether a particular crack is a repair candidate depends on its length, location, and condition, so follow your shop procedures and local rules about repair versus replacement.
A Pre-Repair Checklist
- Inspect the crack, its ends, and the edge of the glass
- Decide whether repair is appropriate under your shop rules
- Clean and dry the area
- Level the tool and check for even contact
- Choose the resin recommended for long cracks
Resin and Curing Matter
Long cracks need resin that flows along the full length and a curing light that reaches the whole repair. The company lists long crack resin among its resin types and describes testing for long cracks under FMVSS 205 and ROLAGS.
Training and Practice
Practice on scrap glass before working on a customer’s vehicle. The site lists training videos for crack repair. Time spent learning the tool saves resin and rework.
Where to Read More
Shops researching a windshield repair kit for long cracks can read the long crack kit page at Ultra Bond, which describes the sliding tool, the crack opener, and the related upgrade options. The company lists 1-800-398-2663.
Document Each Job
Take before and after photos, record the crack length, and note the resin used. Good records protect the shop and help you improve your process over time. Review a few finished jobs each month with your team, compare the photos, and discuss what could be done better next time.